From the point of view of accuracy in the Measurement of Electrical energy sho

From the point of view of accuracy in the Measurement of
Electrical energy should we select a potential transformer
or a capacitor voltage transformers?.Kindly support your
reply with reason and justification.

Question Posted / mohd gulfishan

1 Answers
3942 Views
I also Faced
E-Mail Answers

From the point of view of accuracy in the Measurement of Electrical energy should we select a pote..

Answer / pravesh

only potential transformer is used in order to calculate
the exact reading of voltage as pot trans. is
instrumentation transformer and can can only be used for
metering and protection purposes

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What is the formula to calculate the size of Aluminium and copper cable?

0 Answers

why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?

0 Answers

What are ampers.30kw motor.440volts.

5 Answers Pam Glatt,

1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?

0 Answers APCPDCL, Voith,

Why Ferranti effect is occoured in leading power factor load in a overhead transmission line?

1 Answers

Slip at maximum torque depends on A rotor resistance and reactance B stator reactance C load current D stator resistance

1 Answers

After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.

0 Answers Transco,

Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?

0 Answers Siemens,

In D O l starter motor starts as a star connected ,then in star delta starter also motor initially starts as star how come star delta is preferred from dol

2 Answers

HOW TO CUT A CAKE IN 8 PIECES IN 1 STROKE

3 Answers

what is DG A,B,C,D check?

1 Answers

in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

0 Answers

For more Electrical Engineering Interview Questions Click Here