what is the advantage of open drain, open collector of fet,bjt?

what is the advantage of open drain, open collector of
fet,bjt?

Question Posted / p.mgr

1 Answers
12300 Views
I also Faced
E-Mail Answers

what is the advantage of open drain, open collector of fet,bjt?..

Answer / a3b2

Because the pull up resistor is external and need not be connected to the chip supply voltage, a lower or higher voltage can be used instead. Open collector circuits are therefore sometimes used to interface different families of devices that have different operating logic voltage levels or to control external circuitry that requires a higher voltage . (e.g., a 12 V relay).
Another advantage is allowing to connect more than one open-collector output to a single line. If all outputs attached to the line are in the high-impedance (i.e., logic 1) state, the pull-up resistor will hold the wire in a high voltage state. If 1 or more of the device outputs are in the ground (i.e., logic 0) state, they will sink current and pull the line voltage near ground.

Is This Answer Correct ?

2 Yes

2 No

Post New Answer

More Electronics Communications Interview Questions

How is cad used with electronics?

0 Answers

What is meant by high frequency carrier gating?

0 Answers

why is there -48 v DC voltage use in CISCO Router.?? is there any advatage to use this type of negative voltage rather than positive voltage??

1 Answers

why we used -48 dc volt for telecom equipments ?

2 Answers

What is the use of fbus protocol?

0 Answers

I have need to pervious examinations questions and answer for RRB examination in technical, JUNIOR ENGINEER PLEASE SEND EXAMINATION QUESTION AND ANSWER MY ID k7_r@indiatimes.com

0 Answers ME,

how can trace the fault in any PCB? what are the steps to find problem & to troubleshoot?

0 Answers

What is space charge width?

0 Answers

What precautions are required to be observed in the use of leds?

0 Answers

In 7-segment display system, zero blanking is used to blank out A All the leading zeros B All the trailing zeros C The zero in the MSB(location) D a and b

1 Answers

friends, in closed loop system bandwidth is encresed comparision to open loop. what is mean by that? generally bandwidth means something realeted to frequency.

1 Answers BARC,

Explain why the input impedance of op-amp is so high?

0 Answers

For more Electronics Communications Interview Questions Click Here