any input on how to spec out(if possible) a larger grain structure(3/8" o

any input on how to spec out(if possible) a larger grain
structure(3/8" or larger) on a Al 6061 forging material.

Question Posted / percy verdeflor

0 Answers
2243 Views
Novellus, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Metallurgy Interview Questions

what is the difference between stainless steel and alloy steel?

0 Answers

What is round-robin scheduling in OS?

0 Answers Essar,

Is there a possibility of inducing stress cracking in an insulated stainless road tanker vessel (20 tonne capacity) if the vessel is subject to rapid filling (10 tonne /hr) with liquid methane (-160 c) assuming the vessel is at ambient. If so, where could I obtain suggested cooling rates?

0 Answers

What is hardest cutting tool material?

0 Answers NIC,

exact defination of indurance test

1 Answers

Define what is widman statten structure?

0 Answers

What is the usgae of angle plate ?

0 Answers Essar,

Is it possible to use metallurgical inverted microscope to other designation?

0 Answers

what is a type of graphite in cast iron?

3 Answers Balaji, Sail,

what is the strongest metal? How would a salt and water solution clean a penny but a vinegar and salt solution will not clean a penny? Define what is the cause of this?

0 Answers

carnot cycle has maximum efficiency for ?

0 Answers NIC,

What is the most ductile metal?

0 Answers NIC,

For more Metallurgy Interview Questions Click Here