can you email me addres of kartar coaching GKP for rrb
mombai exams for techanical cadre i.e diploma in mechenical engg
Answer / manish gupta
Mohhadipur cauk,
opp. Police chuki,
Gorakhpur
| Is This Answer Correct ? | 4 Yes | 1 No |
what is the unit of force in C.G.S system and F.P.S system?
What are the causes of damage to propellers?
what is the use of vacuum balancing valve in CEP
which actor do u like ?
The higest value of thermal conductivity is expected for a.) Solid ice b.) Melting ice c.) Water d.) Boiling water Give the thermal conductivity value for each.
what is hardness range of IS 2062 grade casting?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Define pitting.
i want how the pattern of interview goes on for mahindra& mahindra company? plz send me as soon as possible
What is endurance limit and what is its value for steel ?
compare diesel engine and gasoline engine emission?
why don't we use 2 nd angle and 4 th angle projections ??????(since there is also NOT overlapping of VIEWS in 2 nd angle and 4 th angle projections)
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)