Answer / nanda

U can first measure the rotor speed at full load using a
tachometer..note down the Rated speed frm the panel board
and take it as NS.. rotor speed as NR.
Slip is equal to NS-NR/Ns....so the rotor freq Fr is
slip * AC supply frequency

Answer / manikiran

Frequency of a rotating machine can be found by Stroboscope..
It makes use of Stroboscopic Effect.When the frequency of
the Incident light is equal to the rotating speed (measured
as frequency of the point moving ) it appears to be
static...and the corresponding speed gives the speed of the
machine..
Or it can also be measured by a tachogenrator...

why we ground the scondary of current transformer.

4 Answers  

---

why high voltage is reqiured or L.T. panels? what type of tests should be taken for electrical panels?

2 Answers  

---

why the earth conductor in top of the tranmission line ?

2 Answers  

---

11/.433KV, 100KVA TRANSFORMER is supplied with .433KV AT ITS PRIMARY. HOW MUCH KVA IT CAN SUPPLY

8 Answers   ABB,

---

HOW MUCH CURRENT CAN CARRY A 50 kvar DELTA CAPACITOR BANK?

2 Answers  

---

with the help of drive can we run the 50hz motor on 100hz,what will be its effect.

3 Answers   BPL,

---

Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.

1 Answers   HAL,

---

What is maximum rating of transformer ?

2 Answers  

---

Current chopping mainly occurs in air blast circuit breaker.why?

1 Answers  

---

What is skin effect?

2 Answers  

---

what is neutral grounding? why is it required? what is neutral grounding resistor and how is its value calculated??

11 Answers   NTPC, ONGC,

---

what is ideal insulator. what are its parameter. Is poecelain insulator comes under this category.

3 Answers  

---