If an ID Fan is designed for a suction pressure of

If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg, and it is installed in a system where the required system resistance at suction is only -50 mm wg, will the ID Fan be able to produce a discharge pressure of +350 mm wg?

Question Posted / saumabha bagchi

1 Answers
2311 Views
I also Faced
E-Mail Answers

If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg,..

Answer / saumabha bagchi

Theoretically yes, as the differential pressure is -400 mm wg [-250 - (+150)] or [-50-(+350)] in either case. But is this true in practice ?

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

what is compressor?

7 Answers L&T, TVS, Wabco,

1hp=how much rpm

1 Answers

What is the difference between gear motor and a stepper motor? Like i want to use gear motor for its excessive torque to move my robot. Can i use stepper motor instead?

0 Answers

Why R12 refrigerant is restricted to atmosphere?

2 Answers

What is pour point?

1 Answers RRB,

can i get Mahagenco sample question paper?

0 Answers

sir please provide with the technical papers of mechanical stream at earliest for hpcl exam..or refer any link to get the same??????

1 Answers HPCL, NTPC,

What are the causes of troubles in boiler during operations?

0 Answers ABC Inc, RRB, Siemens,

Tell me how much water pressure will come from gravity feed tank, which is 10 metres high?