The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

The friction plate is always mounted on a) flywheel b) Pressure plate c) Internally splined hub d) Clutch spring

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

Define Octane number and Cetane number

0 Answers   GM General Motors,

---

---

Is boiler a closed system?

0 Answers   GM General Motors,

---

What is an injector pressure in heavy vehicles? Why it is used?

0 Answers  

---

What is engine efficiency?

0 Answers  

---

How fuel tank capacity is decided for any two wheeler or four wheeler ???

5 Answers  

---

What is a “proximity probe” used to measure?

0 Answers   Mobius, Tech Mahindra,

---

Which would you use - hydraulics or pneumatics?

0 Answers   Ashok Leyland,

---

Why different types of sound are produced in different bikes though they are run on Si engine

0 Answers   GM General Motors,

---