Answer / bips

Heavy rains

Difference between ac and dc

0 Answers   Eaton,

---

In an existing power plant (phase I) with step up transformers (3nos) with Ynd1 vector group to the 400KV bus bar,an extension power plant (phase II) with transformers (4nos) with Ynd11 vector group >. what are the consequences of such configuration ,please note that % impedance are also differ i.e. 15% & 10.5% the reason was that auxiliary supply interface is at different voltage levels i.e 400v & 6.6KV in phase i and phase II respectively .please advise ! Thank you !

1 Answers  

---

Handpump harness water dont go back.Why?

1 Answers   Focus Energy,

---

i want MEIL placementt papers

0 Answers   MEIL,

---

alternator make voltage 120 degree. as we change degree ex. 100 and 160 or other degree then voltage make. yes or no and why

0 Answers  

---

why we use transformers?

0 Answers  

---

Basic questions asked in HPCL(instrumentation) in refinery section

1 Answers   HPCL,

---

how we can calculate the load appeared on programable logic controller.and what is the method to calculate the scan time of PLC.

0 Answers   Siemens,

---

what electricalcable size for 132kw motor 4pole

0 Answers  

---

How can u find reactive loads(Kvar)?

0 Answers   econ,

---

zeroth law of thermodynamics

0 Answers  

---

Question 95 - The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.

1 Answers  

---