I have connected 04nos. earthings to a transformer through 04nos. earthing pits seperately. 02nos. earthings are connected to T/F body, and 02nos. earthings are connected to T/F neutral.T/F capacity is 2000KVA, 11KV/415V. But after completing of 02 years successful operation ,we are facing following problems- 1. CT/PT occured blast one time 2. HT cable box occured blast two times 3. One body earthing strip and one neutral earthing strip of transformer are overlapping at some places. Whenever these two strips are pressed at overlapped points, they made spark. What is the reason of spark? Please explain the reason & rectification of above problems

5 Answers  

---

In the case of petrochemical area AC drive & AC motor is used where the speed variation is required. Why they are not Using DC drive & DC motors in such areas?

1 Answers  

---

What is use of reactor..how it is help ful in electrical system .....brief explain

1 Answers  

---

HOW CAN I GET 5CORE HO7 CABLE SIZE IF I HAVE 1800A?

0 Answers  

---

why write 500v on line tester (Test pen)

3 Answers  

---

What is accuracy of a measurement?

0 Answers  

---

what is difference b/t ac current and dc current

4 Answers   L&T, Meghana Engineers,

---

difference between turns ratio and transformation ratio?

2 Answers  

---

Ceiling Fan and Storage type water heater. Discuss

0 Answers   Satyam,

---

In a panel 2500A ACB is the incoming breaker then what is the size of the bus bar?

1 Answers  

---

I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?

0 Answers  

---

what is cogging in motors?

1 Answers  

---