im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me!
Thanks very much
No Answer is Posted For this Question
Be the First to Post Answer
Why cold water is used for Boiler Hydro test
what is IR in differential test on motor?
What will happen if id fan on boiler not functioning?.Can the Boiler run without id fan? What is the effect?
I want to build 100 megawatt hydel dam. What does mean, 100 MW per hour? then how many electric bulb of 100 Watts the dam would lit?
A 5A rewirable fuse blows when 9A flows.determine the fusing factor?
1 Answers Schneider, Student, Tata Power,
why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)
Why high pressure turbines are single flow
Calculating Seawater consumption for SWFGD system
why we use reduction gear box to reduce turbine high rpm to 1500 rpm in small plant
3 Answers Maruti Suzuki, Sail,
What is reheated protection
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)