In Single Phase AC Supply,If Voltage between Phase and Neutral is 230V means what will be the Voltage between Phase and Earth?
Answers were Sorted based on User's Feedback
Answer / riyaz
If the earthing is100% good then the voltage must be 230,ofcource its impossible. but voltage between earth and phase 220 or 210.Voltage decreasing indicates level of earthing failure.
Is This Answer Correct ? | 6 Yes | 0 No |
Answer / prashant soni
Voltage between Earth and neutral shall never be more than 2V.
V between earth and neutral should be zero.
Voltage must be 230, of cource its impossible.
Voltage between earth and phase 220 or 210.
Voltage between Line to Line :- V
Voltage between Line to neutral or Line to Earth = V/(1.732)
Is This Answer Correct ? | 0 Yes | 0 No |
Any one can explain if there is any harm from humming noise heard from air circuit breaker : we have 415 switch board having two incomers from transformers 3.3KV/415V , when bus coupler closed, and open one ACB incomer to work in one of the transformers, the current started hunting around 50 Amps, and heard humming noise from the air circuit breaker, although the load current was only 1200 amps while the ACB capacity is 2500 Amps, and the transformer 1600 KVA. The same didn't happen when taken the other transformer offline. Why this humming noise and current fluctuation? is there any implication or danger, bearing in mind that we just returned everything back to normal and stopped the maintenance of the transformer. Shall we go ahead and ignore this noise?
What is the formula to calculate the rating of a three phase trnasformer
A.V.R maintains the voltage of a generator when it is in island mode but when the generator is synchronised with grid it maintenance the P.F,how it happens please any body explain it in detail.
How much dc volt applied in cathodic protection system?
what is mean by harmonics
What is the difference between alternator and generator?
Ceiling Fan and Storage type water heater. Discuss
If the secondary winding will be open in current transformer, how to damage the insulators
HOW DISTANCE PROTECTION IS DONE IN EHV TRANSMISSION LINES? WHAT IS THE BASIC TECHNIQ OR FUNDA USED BEHIND THIS ? SPECIALLY EXPLAIN?IMPEDANCE METHOD.
what is difference Auto-transformer and ICT ?
Why we have use 3 & 1/2 core cable use for general electrical supply arrangement
How the oil level of the Buchholz Relay come down.