Answer / sreejith

I will give the basic for calculating the plastering quantity for 100 m2.You can use the same way based on your required mortar volume

Let Area to be plastered=100 m^2
& Thickness of plaster= 12mm=(12/1000)m= 0.012m
Volume of mortar required= 100 x 0.012= 1.20 m^3
Add 20% extra mortar for filling joint,depressions and
wastage.

Volume of the mortar= [0.20 X 1.20]+ 1.20=1.44 m^3
[Wet Volume]

Increase further by One-third of the volume to get Dry
volume
Quantity becomes= [(1/3) X 1.44]+ 1.44=1.92 m^3

Summation of proportion=1+5=6
For 12mm plastering in 1:5 cement:sand mortar mix,

1)Cement required= 1.92/6= 0.32 cu. m
No. of bags of cement= 0.320/0.0347=9.22 bags
>>9 bags(say)
Kgs of cement required=9 x 50= 450 kg (approx)

2)Sand required= [1.92 x (5/6)]= 1.60 cu. m


[Weight of 1 bag of cement= 50 kg
Cement should be always measured by weight to avoid
variation.

One 50 kg bag of cement weighs 1440 kg/cu. m
Volume of 1 bag of cement= 50/1440=0.0347 cu. m ]

Therefore to convert Cu. m into No of bags of 50 kg
cement,just divide the volume of cement by 0.0347

Answer / ajay patel

first find perimeter of cylinder that is (3.14 * D)
then multiplied by height of cylinder
do same for both side
you will ger ans in square meter

Answer / hanamareddy maddur

01) volume of plaster=area of plaster*thickness of plaster=8.15*.012=.0978 m2
02) 20 % extra for joint filling &wastage=.0978*.2+.0978=.117m2
03) 1/3rd volume increase to get the dry volume=1/3*.117+.117=.156m2
04) sum of proportion-1:3(1+3)=4
05) cement qty=cement proportion*volume of mortar /sum of proportion
06) cement qty=1/4*.156=.039*28.2=1.1 bag
07) sand qty=sand proportion*volume of mortar/sum of proportion
08) sand qty=3/4*.156=.12m3

What is rolling stock

0 Answers  

---

How to calculate the cement consumption in RR Masonry in CM 1:8 for the foundation of Ground Level Reservoir

0 Answers  

---

For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.

0 Answers  

---

on what basis the partial factor of safety are decided? form the load combinations

0 Answers  

---

what is meant by camber

1 Answers   NCC,

---

---

very simple or less time consuming formula for reinforcement calculation by moment

0 Answers  

---

Two types of piling

8 Answers  

---

What is difference between MS and Tor steel ?? Please ellobrate...or state its charactersitcs??

4 Answers   CLG, Indiabulls, TOR,

---

how to convert kg/m3 to kg/cft

6 Answers   L&T,

---

What is ld in beams column and slab.

1 Answers   Manas Group,

---

what is the difference between linear and curved elements?

0 Answers   Al-Hamd Academy,

---

How to find arc area with using angle?with out using angle?

1 Answers  

---