Answer / rishiraj

500KW/hr = 500 units
500KW/2hr = 1000 units
So after 2 hrs meter will show addition of 1000 units in meter reading.
E.g.: Before operation of 2 hrs meter reading is 5000, then meter reading will be 6000 after operation of 2 hrs.

Answer / pradeep kumar satapathi

If load is constant for two hours then the total consumption or generation will 500+500 i.e. 1 MW ONLY.

how to measure dc earth leakage current?

0 Answers  

---

why can not run two different phase circuit in to the same conduite

1 Answers  

---

Alternator rotor earth fault relay circuit

0 Answers  

---

what difference between thermal and bi-metal over load relay?

2 Answers  

---

If OLTC is in manual position there is chance to variation of voltage(Low or High)?

1 Answers   Juniper Networks,

---

hi engineers,if suppose distribution is going to two diff village mistakenly they r interchange the neutral of twowhat happen?

7 Answers   Bhel, L&T,

---

why current coil has less number of turns compared to pressure coil?

8 Answers   Airtel,

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

---

Graphs of measuring power and speed on dc motor

0 Answers  

---

what do you know about electrical

15 Answers  

---

Is there any particular formula for sizing the bus bar based on the current rating

1 Answers   Bunt Solar,

---

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

0 Answers  

---