Answer / Munish Kumar Gautam

LED bulbs used for three-phase power indication might have a specialized design that allows them to work correctly even without Current Transformers (CT) or Potential Transformers (PT). This is possible due to the use of a phase-sensitive indicator circuit inside the LED bulb, which can determine the phase by analyzing the voltage waveforms. If one phase is cut, the circuit may still show the correct indication by detecting the change in the remaining phases.

Why should compressed gas cylinders stored in upright position describe the cause?

0 Answers   DEWA,

---

Explain overhauling stopsfor backpull our pumps?

1 Answers   BridgeStone,

---

What are the areas where I need to make improvement? (Please provide examples and suggestions for improvement).

1 Answers   PMG, SPML,

---

why data registers are needed in PLC ?

1 Answers   Samtel,

---

how the calculation of faut current level

1 Answers   ABB,

---

What is the purpose of cost accounting?

1 Answers  

---

What you know about iso 9001? What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?

1 Answers  

---

what casues little rust pockets to pop through or off concrete cylinder blocks (home)?

1 Answers  

---

What is load line in control valve?

1 Answers   KEC, NJPC,

---

i gotadmission in southeast missouri state universit ive got scholarship too my gre is 860 and ielts 6.0 bands and B.E 59.3% with 5 backlogs what are chances that i get visa????/

1 Answers  

---

what is differance between PLC system and DCS system Proggramming. Give me answer. Thanks.

4 Answers   UltraTech,

---

What is difference between Hazard & Risk

2 Answers  

---