Why induction motor overheated?

Question Posted / rkabireee

2 Answers
3680 Views
HVCC, Physical Research Laboratory (PRL), I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why induction motor overheated?..

Answer / k.prakashchandra

Inter turn short , over voltage , overload , bad cooling , bearing friction, unbalanced voltage ,....

Is This Answer Correct ?

2 Yes

0 No

Why induction motor overheated?..

Answer / shahbaz

The reason of overheating is generally due to i2R losses and in induction motor the current drawn by motor is high as there is air gap to produce the magnetizing current and also the flux density is required high. hence over heating occoures

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Define transfer function?

0 Answers

An 11kv system consisting of an underground cable to a sub station about 300 meters away was shut down for about 10 hrs. On energising, it tripped off on earth fault about 10---20 mins later 6 times but since than it is not tripping.its already 3 weeks now. The SPAJ was found to be fine. what could be the cause.No test had been done to determine the cause of the trippings till now because of demand.

2 Answers

why we are using panel space heaters in different control schemes????

3 Answers Mecon,

Do you know how to measure the earth resistance? if so explain it

42 Answers ABB, BEL, BridgeStone, College School Exams Tests, Dalkia, Dalmia Group, DEC, Electrical, Genpact, HEC, IOCL, JLL, L&T, MSEB, Saraca, Sical, Telecommunications, University Exams,

state the disadvantages of carbon filament???

0 Answers

Why Indian Electricity frequency desined 50 Cycles as developed countrys are using high frequency with low voltage

1 Answers

difference b/w semiconductor and dielectric

2 Answers

Why have the transformer one earthing to their neutral? Why have the transformer many earthing to their body?

1 Answers

What will be result if we connect LT votage to the terminal of HT motor?

0 Answers Equate,

We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.

0 Answers

what is the difference between droop mode and ischnorous mode in thermal powerplant?

0 Answers GVK, Thermax,

why in a swquence network representation, the negetive sequence generated voltage is taken as zero?

0 Answers

For more Electrical Engineering Interview Questions Click Here