Why we are always only used 11 kv. , 22 kv ,33kv

Why we are always only used 11 kv. , 22 kv ,33kv in transmission line? Why not use 25, 55 ,65 kv ?

Question Posted / ashok

3 Answers
5548 Views
Khidmah LLC, Precision Camshafts Limited, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why we are always only used 11 kv. , 22 kv ,33kv in transmissi..

Answer / ukumar

rms/form factor=1.1 its multification factor of transmission so its calculate 11,33,66....

Is This Answer Correct ?

10 Yes

2 No

Why we are always only used 11 kv. , 22 kv ,33kv in transmissi..

Answer / achal

It has no answer. People say and link it to some equations but for real it has been chosen randomly and now it has became an standard.

Is This Answer Correct ?

3 Yes

3 No

Why we are always only used 11 kv. , 22 kv ,33kv in transmissi..

Answer / engr ahmad

our teachers in University has also said like this that actually this is 13 kv generated and not 11....so i think its not necessarily 11. it could be any...

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

How much KVAr bank reqired for 630 KVA transformer on full load for maintain power factor upto.99

4 Answers Dhanalakshmi Industries, DLF,

what is sloop? what is meen LLB in and difine?

0 Answers

IS RTCC AND OLTC REQUIRED FOR 500 KVA 11KV/433V TRANSFORMER FOR AN INDUSTRY?

7 Answers IGCAR, TNEB Tamil Nadu Electricity Board,

What should be value of Circuit breaker operating time and tripping time?

5 Answers

I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers AIS,

As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?

0 Answers

what happen if steam turbine trip,g.c.b not open and excitation off and on condition?

1 Answers

how to calculate cable size in transformer, distribution side?

1 Answers

What is maximum power transfer theorem?

0 Answers

In 63kva LT Distribution Box Why the outgoing of 63A kit kat is connected to 200 A link disconnector? as the output of kit kat is only 63 A?

1 Answers Godrej, Patel,

Generally we denote power in 'p',voltage in 'v'but why can't we denote current in 'c' instead of I.

4 Answers Bhel,

although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?

0 Answers

For more Electrical Engineering Interview Questions Click Here