Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are always only used 11 kv. , 22 kv ,33kv in transmission line? Why not use 25, 55 ,65 kv ?
- 3 Answers
- 5253 Views
- Khidmah LLC, Precision Camshafts Limited, I also Faced
- E-Mail Answers
Answer Posted / engr ahmad
our teachers in University has also said like this that actually this is 13 kv generated and not 11....so i think its not necessarily 11. it could be any...
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
Why is voltage is required to be within permissible range for an electrical equipment?
What are the types of instrument transformer?
What is online and offline ups? how does it works?
3phase motor can be used as a Prime mover for alternator.
What is reverse power relay?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
How can we calculate cable size in Low voltage & high voltage
Instrument connected to a single phase supply
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
what is the VA(Volt-amphere)? define with calculation?
what is the range of maximum DOL and SDS can be use for pump and fan application
