Answer / Mohit Singh Chauhan

To perform Megger test on an 11 kV cable, follow these steps:
1. Ensure that you have proper safety equipment (rubber gloves, insulating tools, etc.).
2. Disconnect both ends of the cable from its sources.
3. Connect one end of the Megger to one terminal of the disconnected cable and the other end to ground.
4. Record the reading on the Megger. The acceptance IR value for an 11 kV cable is typically less than 50 micro-ohms.

a voltmeter shows 100v..wat is to be done to make it read 150v.

7 Answers  

---

what will happen if capacitor bank is used in generation side?

2 Answers  

---

What is the tension required for the 25000 CFM AHU belt

1 Answers  

---

what is difference between fuse and circuit breaker?

4 Answers  

---

What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?

1 Answers  

---

what sq.mm copper pvc wire need for ac load current 25amps for 230v ?

4 Answers   Khadamat, Siemens,

---

what happen when generator neutral supply and transformer neutral supply linked

3 Answers  

---

Generator protection &generator test

1 Answers  

---

What's the difference between a generator using 50Hz and 60Hz? When do we need to use a generator 50Hz and 60Hz?

3 Answers  

---

What is meant by inverse definite mean time (IDMT)& definitemean time (DMT)?

5 Answers  

---

what will happen if ac power supply is given to the rotor of an alternator

1 Answers   Goldman Sachs,

---

What is Synchronization of generator,where and how it is achieved.

1 Answers   HEC,

---