In Power Line Communication (PLC) the wave trap is used to block communication

In Power Line Communication (PLC) the wave trap is used to
block communication signals from entering neighboring
lines. My question is this: Why do they allow for
different filtering arrangements on these wave traps?
Isn't it always going to be a low pass filter since we want
the power frequency to go through, and the comm signal
blocked?

Question Posted / scott

0 Answers
1984 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

What is the formula to find out cross sectional area of cable for certain current rating?

1 Answers MRF,

Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?

0 Answers Danieli,

what is induction relay

1 Answers

What difference between MCB,MCCB,RCCB,ELCB please explain briefly with its rating.

3 Answers

3. What is Impedance Voltage in Transformer?

16 Answers KESC, L&T, Torrent Power,

What is meant by Load Encroachment in OHL Feeder Protection?

0 Answers

where they are using surge arrester and lighting arrester? how they connect? what is the purpose of that?

1 Answers

How Kneepoint voltage of CT practically related when CT in service. ie Knp is above 670 what exactly means

0 Answers ABC,

Why delta connected motors are used normally.

4 Answers

What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.

0 Answers

what is the diffrantial relay???????why we use it on the MDB

5 Answers

what is the reason of power development in synchronous generator due to saliency ?

1 Answers

For more Electrical Engineering Interview Questions Click Here