Answer / nisahnth

pressure switch is like an electronic switch,when crosses
set point the switch will changes to NO to NC or vice versa
so out put is DI,

pressure transmitter monitoring the pressure it send the
analog signal to DCS

Answer / madhavan

Pressure switch output is interms of NO or NC.

Electronic pressure transmitter output is in 4-20 mA or VDC

Answer / senthil

The output of pressure switch is the contact changeover, i.e. from NO (normaly open) to NC (normally close) or vice versa, when the pressure setpoint is crossed in either way.
Whereas the output of Pressure transmitter is 4 to 20 mA or 1 to 5V as the case may be with the type of transmitter you are using.

Answer / ashraf

Pressure switch output is 0 or 1 .if switch is NO it means 0 if NC it means 1. And the tx output is 4 to 20mA.

Answer / ashraf

Pressure switch output is digital 0 or 1 .if switch is NO it means 0 if NC it means 1. And the tx output is 4 to 20mA.

Why rtd  out put is ohm how create the ohm 

1 Answers   Samsung,

can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?

0 Answers   TCS,

Why we use 250 ohm resistor in series with HART protocol communication?

13 Answers   Chemtrols, Instec, Sabic,

what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .

0 Answers  

what is scale factor of proximitor & unit of the vibration.

0 Answers   ADMA OPCO,

If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?

0 Answers  

Explain bernoulli’s theorem.

0 Answers  

what is an ambient temperature?

5 Answers   Reliance,

How can you differentiate Instrumentation to Electrical?

1 Answers  

is manifold required for an integral orifice meter?

2 Answers  

what is use single seated and double seated valve?

2 Answers   Doha Petroleum Construction DOPET,

Please any one can explain how to calibrate transmitter (smart) online with out remove from the container suppose it is interface level or static pressure level measurement we dont want to remove transmitter from the container mean it is running plant please give me detail. thankx brothers

1 Answers   KNPC,