1. What kVA rating is required for a transformer that must handle a maxim

1.

What kVA rating is required for a transformer that must
handle a maximum load current of 8 A with a secondary
voltage of 2 kV?

Question Posted / mds.1490@gmail.com

3 Answers
9497 Views
BCPL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

1. What kVA rating is required for a transformer that must handle a maximum load current of 8..

Answer / maurilio

at least it is necessary a 16 KVA if the load is a
resistive one
if not it is necessary to know the cosFi

Is This Answer Correct ?

9 Yes

2 No

1. What kVA rating is required for a transformer that must handle a maximum load current of 8..

Answer / somu0507

Answer 16 kVA given by Maurilio is correct and it is correct for any type of load i.e. resistive, inductive or capacitive.

Is This Answer Correct ?

3 Yes

1 No

1. What kVA rating is required for a transformer that must handle a maximum load current of 8..

Answer / phillip

somu 0507
resisitive

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is full wave bridge?

4 Answers

Describe the test procedure to determine the vector group

0 Answers MPSEB,

What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?

0 Answers HPCL,

When dc supply is fed to rotor of the alternator how it work?

0 Answers

HOW TO REDUCE POWER PLANT AUXILIARY POWER CONSUMPTION?

0 Answers TATA,

What is the minimum insulation value required for a cable between phase to phase and phase to earth of 380 Vac 50Hz circuit, having load arround 800 amps.

2 Answers DEWA, TATA,

Why Batteries are rated as AH i.e AmpereHour,and its formula to converting AmpHour to Amp

4 Answers Suzlon,

How can you calculate in detail the VA burden of current transformer used for Restricted earth fault protection? Please understand that the CT required here is Class PX or X. Also please show the calculations for knee point vtg, stabilizing resistor, magnetising current.

3 Answers

why rating of transformer is in kva instead of kw?

3 Answers

what is the relation between frequency and inductive reactance in a d.c supply?

2 Answers L&T,

difference between slippring induction motor and Generator?

1 Answers

how to calulate multiplying factor if meter ratio is /5 ampere and ct ratio is 100/5 ampere.(our supply is 3 phase 415 volts)what is multiply factor?

3 Answers Vivek Engineers,

For more Electrical Engineering Interview Questions Click Here