I have a small system with two motors that are running on
380 vac, 60 hz. These motors are expensive and I usally get
them from Brazil. I am adding another motor to the system,
but I want to purchase a 480 vac, 60 hz motor to use. It
will be on a VFD that is rated fro 380 thru 480. Is this
posible and will I have to use a larger motor and derate it?
No Answer is Posted For this Question
Be the First to Post Answer
What is meant by Guard relay ?
can we synchronize star system generators with delta system transmission line ? and how ?
Name some application zrea where IDMT relay can used?
how much insulation resistance 11kv & 33kv under ground cable between earth to phase & phase to phase.
Cummins 750 KVA generator how much disel consumed per hour and how many units generated on 100% full load.
why we not using 230kv directly why we are stepping down and then stepping up
how does a tube light choke working?
what is the transformer
Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian
what is the pressure in side transformer under normal condition?
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
what is means of ALF,kPV(min),lexc(max)at Vk,Rct@75 degree centrigate ohm in current transformer name plate?