Answer / Prakher Tandon

Semi-custom and full-custom are terms used in electronics design to describe the level of customization in a product. Semi-custom products offer a predesigned, but still customizable, layout for the customer to use. Full-custom products allow complete design freedom for the customer.

how can I pass ccna in first try in one month

1 Answers  

---

Susan made a block with small cubes of 8 cubic cm volume to make a block ,3 small cubes long, 9 small cubes wide and 5 small cubes deep. She realizes that she has used more small cubes than she really needed. She realized that she could have glued a fewer number of cubes together to lock like a block with same dimensions, if it were made hollow. What is the minimum number of cubes that she needs to make the block? a) 114 b) 135 c) 21 d) 71

3 Answers   TCS,

---

A channel has a bit rate of 4kbps and a propagation delay of 20msec. For what range of frame sizes does stop-and-wait give an efficiency of at least 50%

1 Answers   Chongqing University of Posts and Telecommunications,

---

CAN A GSM MOBILE TOWER ESTABLISH WIFI FACILITY?

2 Answers  

---

Why is modification of signal required for transmission Over channel?

5 Answers  

---

Why we need biasing for transistor, fet and mosfet?

1 Answers  

---

Sparking occur when a load is switched off because the circuit has high a.) Inductance b.) Capacitance c.) Resistance d.) None

14 Answers   Biwta, BSNL, CDS, DMRC, Infosys, SSC,

---

Explain the operation of 1φ sinusoidal ac voltage controller?

1 Answers  

---

What is the difference between active and passive filters?

1 Answers  

---

For 65hp motors how kvr capacitor should be on??

1 Answers  

---

Suppose you have been asked to design one electronic circuit then starting from basic what procedure do you follow?It should include all standard industrial measures. Please reply.Thanks.

1 Answers  

---

What do you understand by reverse saturation current of a diode?

1 Answers  

---