Answer / ram

it is an anchorage length it used in beam columns junctions generally 50dia

What is pile foundation?

15 Answers   GMR,

---

For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?

0 Answers   CDM Smith,

---

1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.

0 Answers   Ramky,

---

How to calculate the compressive strength of 28 days of concrete where we have 7 days compressive strength?

2 Answers   ACF,

---

which type of crust is best suitable to develop flexible pavement in rural roads i.e either with wet mix macadam or Water Bound Macadam and its reasons.

0 Answers  

---

how to calculate the strength rebound hammer test if average reading of 50.6,50.2,49.1,50.5,50.8,51.7 in grade M-60

1 Answers   L&T,

---

what is right & short method of measurement of slab&beam

0 Answers   L&T,

---

manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.

0 Answers  

---

What is the difference between one-way slab and two-way slab?

0 Answers  

---

The properties of concrete HA-30 and how does it differ with M 30 (specify the important characteristics like workability,strength,mix design,slump test value)and what is the standard relating to it

0 Answers  

---

Factor of safety for steel should be based on its yield stress or its ultimate stress and factor of safety for concrete should be based on its ultimate stress or its yield stress?

2 Answers   NTPC,

---

What is a MIS report?

1 Answers   NCC,

---