how many bulb of 60watt at 300volt is used to maintain 0.25
amp.with valid reason?
Answers were Sorted based on User's Feedback
Answer / ashutosh khadgaray
2 coz
P=VICOS(Fi)
60=300*I*0.8
I=.125
0.125 for 1 bulb so for 2 bulb it will be 0.25
Is This Answer Correct ? | 11 Yes | 3 No |
Answer / ramamurthy
20 of them
4 groups of lamps in series, with each group having 5 lamps
in parallel
Is This Answer Correct ? | 5 Yes | 1 No |
Answer / kapil joshi
Only 1 Bulb
Because Total Power = 300 * 0.25 = 75 W
Required Power For 2 Bulb =2* 60 = 120 W
which is greater than 75 W
So we can use only 1 bulb
Is This Answer Correct ? | 1 Yes | 2 No |
why sec of ct should be kept shorted
how to find the torque of the single phase synchronous motor by doing an experiment
PRV (Pressure relief valve) Trip with oil splash outside power transformers
list the advantages of RCCB over other circuit breakers?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformer
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
At no load the PF of an alternator -Zero -Zero Lagging -Zero leading -None of the above
tell me the operation of ELCB. How it detects a fault?
Differentiate between Low and High impedance Protection
What are the main significances of root locus?
Please define ohm’s law for a.c (alternating current)?
which model T or pie model is prefarable in power syatem