Answer / srilakshmi

Carpet area + terrace + balconies + areas occupied by walls + area occupied by common/shared construction (e.g. lift, stairs, club house, etc). Generally builders use loading factor on carpet area to arrive at superbuiltup area. For example, if carpet area is 500, and loading factor is 1.3, then superbuiltup area is 500 x 1.5 = 750.

for columns reinforcement the lap length is not provided then how to rebar the rods then how rebar should be lapped

4 Answers   Nagarjuna Construction,

---

Please can anybody let me know how to calculate cement, sand & aggregete content for one meter cube of concrete. please if possible provide calculations for cement in no. of bags, sand & aggregate in cu.mt. Thanks.

2 Answers  

---

how to calculate sand in CFT from a concrete foundation (m^3)???

1 Answers  

---

what is the minimum & maximum compressive strength n/mm2 of M-30 mix design cube

1 Answers  

---

CROSS SLOPE OF Macadam Construction

1 Answers  

---

---

What is the procedure of Waterproofing in toilet sunken area ?

2 Answers   ACIL,

---

How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 100 microns?

0 Answers  

---

What is the difference between Fe500 and Fe500D rebars in their appearance and also is there any change in their Yield Strength of these rebars?

1 Answers   Ripple India,

---

Why we take 162.2 in (d*d/162.2) to calculate weight of steel???

1 Answers   Godrej, L&T,

---

resins are not soluble in water soluble in spirit used in varnish left behind on evoporation of oil

0 Answers  

---

What is the full form of APVC Pipe?

1 Answers   GSECL,

---

what would be the rqmnt. of cement and sand (1:6)for building brick wall and also 20mm thick plaster on the wall by same ratio?

1 Answers  

---