• How will you be evaluated at Petro Star Mount, and how
Answer / rakesh.r
|Is This Answer Correct ?||0 Yes||0 No|
PLESE SEND ME OLD TECHNICAL N APPTITUDE QUESTION PAPERS
what is mean by Hydraulic Overload in presses
Dfine the density of plastic?
what is the purpose of fusible plug in boiler and where it is located
Can anyone explain Things gone right(TGR) and Things gone wrong(TGW) in the APQP process? preferable With example.
HOW THE POWER INTERMEDIATE WITH TON OF REFRIGERATION(TR) COMPRESSORS ? HOW THE POWER IMPORTANCE TO COMPRESSOR FOR THE LOAD ?
we have read that when the piston goes up and down then the engine works i.e. the suction,compression etc etc. then what happens in the case of big vehicles, which start at stable condition, i.e. how does their piston moves when they are at rest. how suction,compression etc
What is the basis of selection of type of pump (Centrifugal, Vertical Turbine)
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What is the selection criteria of Natural Draught Cooling Tower and Induced Draught Cooling Tower . Where we prefer NDCT and where IDCT.
Which heating value is indicated by a calorimeter and why ?
what is the techanical difference between german standard & japanese standard.