Answer / k.prakashchandra

Percentage impedance is only a percentage as it is
percentage of I x Z / V and the unit of I x Z is V. V/V is 1

Answer / euclid

Transformer impedance is a ratio
of the transformer’s normal full load current
to the current available under short circuit condition.It was stamped on every transformer nameplate. Why did they stamped it because it is a tested value after the transformer has been manufactured.

Answer / afsal

Percentage impedance is the ratio of voltage drop on full load due to winding resistance and leakage reactance to the rated voltage of the transformer.
Z%= Vd/Vr *100

this can varied at the design stage by varying voltage per turns and geometrical size of the windings.

why cu losses called cu losses.

6 Answers  

---

what is the acceptable limit value for Desolve Gas Analysis/

0 Answers  

---

Why use the VCB at High Transmission System ? Why can't use ACB? Pls explain the ans.

5 Answers   amps, DLF,

---

What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage

0 Answers   Indeco,

---

how to size H.T & L.T Panel ?

0 Answers   Schneider,

---

in 3 phase (4 wire) star connection - is current pass through neutral??

7 Answers  

---

why the earth pin is thicker than other pins in a plug? If it is for reducing resistance, then why the copper earth wire is not so thick as earth pin of socket?

5 Answers   Omax,

---

why v use only sodium bulb or orange color lights on streets, y nt CLF OR TUBE LIGHTS

3 Answers  

---

Why CBCT rating is 50/1A

0 Answers  

---

why not starting switch first connect in direct on line starter?????

0 Answers  

---

what are 3 factors when selecting a contactor for a job?

1 Answers  

---

What are the rating wise protections required for Generators from 600KVA to 2000KVA

3 Answers  

---