What is purpose to use relay after digital output module? Why normally we don&#

What is purpose to use relay after digital output module?
Why normally we don't use relay for digital input module?

Question Posted / plc_alto

3 Answers
8495 Views
Siemens, Sofcon, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is purpose to use relay after digital output module? Why normally we don't use relay for ..

Because digital output module out put lode capacity is low
and use relay then we can incrise the output lode & lode
short ckt proctaction also....
in input module pts not need more current and voltage just
a on-off pules

Is This Answer Correct ?

4 Yes

1 No

What is purpose to use relay after digital output module? Why normally we don't use relay for ..

Answer / madam.bhupal

Is This Answer Correct ?

2 Yes

0 No

What is purpose to use relay after digital output module? Why normally we don't use relay for ..

Answer / senthil

Digital O/P module used as interface relay(isolation
circuit) between controller to the load. we cannot connect
the controller output to the load side, which may required
high amps to energise a contactor coil or etc.,In this way
controller is not get loaded.

Is This Answer Correct ?

3 Yes

2 No

Post New Answer

More Industrial Engineering Interview Questions

business plan for 100 machines in a bulding showing differeng allocation of network devises?

0 Answers

how can LED bulb indication work correctly without CT OR PT for 3 phase indication if one is cut then it will show the correct indication?

0 Answers UltraTech,

How we install and terminate the wire of pressure transmitter and temprature transmitter. Give full explanation.

0 Answers

What environmental controls?

0 Answers

What is the formula for converting litre in to pale?

0 Answers

What is DHCP & work?

2 Answers

WHAT IS SETUP TIME,OPERATION TIME

7 Answers BDL, Goyal Group,

if salary paid per month rs. 50000/- of male <65 i will deduct tds from his salary please what i will do explain?

0 Answers

To heat up 275ltrs. water upto 90 degree what is the capecity of heater required?

1 Answers

if zero ohm is not adjusted on shorting the two terminal of multimeter what does it indicate

0 Answers

what casues little rust pockets to pop through or off concrete cylinder blocks (home)?

0 Answers

What you know about ISO 9001? What is quality management system? Weather QMS is suitable,adequate and effective or not? Is there any Quality Policy? Is there any Quality Objectieve? If yes, then what are they. How they are planning to achieve Quality objectives? Weather they are measuring quality objectives?

0 Answers

For more Industrial Engineering Interview Questions Click Here