Answer / habib

Your question is not clear. Did you mean the scoop tube? If
yes, scoop tube is not the part of BFP. It is the part of
Hydraulic coupling. And not necesarilly all the BFP is
having hydraulic couplings. According to the position of
scoop tube oil quantity(flow rate) of the coupling is
maintained. The higher the oil flow, the higher the output
speed of the coupling and vice versa and same to the BFP.

According to the steam flow rate in the turbine feed water
flow rate should be matched. To get the variable flow rate,
variable speed is required for the BFP. And so far the
hydraulic coupling is the most efffective solution to serve
this purpose.

What is the most important, or helpful,project that you have contributed to?

0 Answers  

---

At 50 Centigrade (Fuel oil) what is its cast?

0 Answers  

---

whether supercharger is used in si engine or not?if it is used then at which destination?

1 Answers  

---

why choke is not exactly placed in the middle of the tube light ?

0 Answers   PTL,

---

I am a mechanical student.And have cleared the written for NTPC. Please suggest what and how to prepare for the interview.i have got only 2-3 weeks in hand.

0 Answers  

---

Difference between turbocharging and supercharging in diesel engines?

0 Answers   VLS,

---

Why certain angle of divergence is to be maintained in venturimeter.

2 Answers  

---

What is the use of the governor on diesel generator

5 Answers   GLA University, Standard Chartered,

---

i am trying to select the correct grade steel for a shaft that will have a flap on it weighing about 4.5 tons being forced up with hydraulic rams. can someone tell me what grade the shaft should be and if it should be stainless steel or not

2 Answers   Rainford EMC Systems,

---

what is the termodynamic?

5 Answers  

---

How you are going to remove corruption?

17 Answers   TCS,

---

what is the Tensile strength of M6 Screw

1 Answers  

---