Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / habib
Your question is not clear. Did you mean the scoop tube? If
yes, scoop tube is not the part of BFP. It is the part of
Hydraulic coupling. And not necesarilly all the BFP is
having hydraulic couplings. According to the position of
scoop tube oil quantity(flow rate) of the coupling is
maintained. The higher the oil flow, the higher the output
speed of the coupling and vice versa and same to the BFP.
According to the steam flow rate in the turbine feed water
flow rate should be matched. To get the variable flow rate,
variable speed is required for the BFP. And so far the
hydraulic coupling is the most efffective solution to serve
this purpose.
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
What is the function of mouth ring
What is a slined joint?
can any1 provide me the PLACEMENT PAPERS FOR BHEL
In which process internal energy remains constant ?
At 50 Centigrade (Fuel oil) what is its cast?
What is brain of the computer?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is the difference between austenite stabilisers and ferrite stabilisers ?
What do you going to observe, when a diesel engine is running?
relation of cop with ikw/tr?
Define pitting.
What is meant by cross flow heat exchanger?
What is a machine shop?
What is meant by counter flow heat exchanger?
What materials are used for engine propeller?
