Answer / rajesh verma

Dear
2000a is the total capacity of your bus bar.from that
busbar there will be onather taping according to your
switchgear rating like if you have 10 outing and three in
among of them is capacity of 250 Amps and rest of 100 amps
then your three feedar will conect with 250a acapacity
busbar & can take max 250 AMP and the rest will connect
with 100 A Bus Bar so it can take 100 Amps max very simple
it all depends on your switch gear rating

What are test signals and their significance?

0 Answers  

---

What iz main protection of mediuum voltage motors and what iz the standard IR voltage of 6.6 and 11kv motors.

1 Answers   GE,

---

why high voltage is reqiured or L.T. panels? what type of tests should be taken for electrical panels?

2 Answers  

---

when two gen set runing in parallel but thay have diffrent pole pitch, then what will be happan

0 Answers  

---

what is the difference b/w conductor and semicoductor

1 Answers  

---

What is the phase relationship between the primary and secondary voltages of a transformer?

0 Answers  

---

why tungsten is used in incandescent lamp instead of nichrome though nichrome has high melting point

2 Answers  

---

You required 5A from the transformer but you get 8A. How do you minimize this?

2 Answers   Bajaj, Siemens,

---

how external lighting design? please give examples?

0 Answers  

---

parallel operation for tansformer which condition fill fil for that

11 Answers   ITC Infotech, Suzlon,

---

dielectric strength of vacuum is greater than SF6 but for 132Kv uses sf6 breaker & for 33kV uses vaccum breaker why such a contradiction?

2 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.

0 Answers  

---