Answer / nishant

induction motors are cheap ,robust easy to maintain there
operation is simple

Answer / simon peter

Easy to handle,low starting torque,cheap in rate,made for the fullfilment of domestic purpose,easily repaired,light weight,high speed...

How many 2 ton window A/c can runs on a 125 KVA generator?

2 Answers  

---

How can we increase the capacity of Energy.?

0 Answers  

---

What is MPCB, MCCB, ELCB, RCCB ? Explain them ?

2 Answers  

---

after how many spot we must chang secondry cable in portable spot welding gun?

0 Answers  

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

What are the possible causes of REF operation on a power transformer

4 Answers  

---

direction of tarbine& genrator

0 Answers   Sandvik,

---

why is the size of earth conductor is half of phase conductor.

1 Answers   Century Pulp and Paper, L&T,

---

why protection and metering CT's are always connected in star why not in delta?

5 Answers   Reliance,

---

Can I use 1 phase power supply to run 3 phase motor? If yes, how?

6 Answers  

---

For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!

0 Answers   Maruti Suzuki,

---

Vibromotor 252MV 1/4HP2P..what is mean by 252MV?

0 Answers  

---