how calculate the ms angle weight formula detail
Answers were Sorted based on User's Feedback
Answer / gopal
. Weight of MS Angle = (2*W-T)*T*L*7840 kg (All units are in MKS)
Where,
S = Width of any side in mtr
T = Thickness of the angle in mtr.
L = Length of the angle in mtr.
7840 is the density of MS in kg / m3.
| Is This Answer Correct ? | 116 Yes | 33 No |
Answer / sunil1505
width * thik / 127 right but it is not in all type of
thickness upto 16 mm only..
if u multiply angles..75 X 75X 6 tha length wit 6.78 u get
weight....
| Is This Answer Correct ? | 43 Yes | 13 No |
Answer / bhawan singh kiraula
how can calculate weight of ms angle in meter per kg
| Is This Answer Correct ? | 19 Yes | 4 No |
Answer / nitesh dagar
For find the actual wt. of MS angle section :- ( Density of steel is 7850 KG/M3 )
Formula is :- Lenght (mm) x Width (mm) x Section Thickness (mm) x 0.0785 / 10 = answer
| Is This Answer Correct ? | 10 Yes | 7 No |
Answer / aaqib surti
Mass of angle= density*volume
Volume=(area* length)
W=((2*a*t-t^2)* l)*0.00000785
A= side of section in mm
T= thickness of section in mm
L= total length of sections in mm
| Is This Answer Correct ? | 3 Yes | 2 No |
Answer / raghavan
see the steel tables for weights of all sections
| Is This Answer Correct ? | 1 Yes | 2 No |
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
how to estimate material requirement for an area of house in square feet?
What is the best mixing ratio of concrete materiloas for raft foundation?
What is dead load impact load live load
0 Answers Osmani Constructions,
What is the Specific gravity of Fine and Coarse aggregate ?
How to cal. The weight of hollow pipe?
FOR SAME AMOUNT OF RAINFALL & EQUAL CATCHMENT AREA THEN WHERE RUN OFF WILL BE HIGHEST?
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
How to calculate soil bearing capacity of soil?
What is the strength of Steel Fe 415 and Fe 500
1 Answers Aditya Constructions,
how much steel required for 1 sq.m area?
24 Answers AA Architects, L&T,
Why the height of the bridges over the river are very low?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)