Interested to Buy Any Domain ? << Click Here >> for more details...
how calculate the ms angle weight formula detail
- 9 Answers
- 76594 Views
- Concor, Puravankara, I also Faced
- E-Mail Answers
Answer Posted / bhawan singh kiraula
how can calculate weight of ms angle in meter per kg
| Is This Answer Correct ? | 19 Yes | 4 No |
Post New Answer View All Answers
How to avoid fly ash seed ball formations in the concrete mixer while mixing of raw materials for fly ash block manufacturing?
Explain what is progress payment?
How to find coloumn vertical cut length floor to floor & lap + bend or anything plz clearfiy
Explain the Strength of brick?
How and where are aqueducts built?
What is the ratio of grades m5, m7.5, m10, m15, m20, m25, m30, m35, m40?
what is that one cub metre plaster in cemant and fine sand
what is right & short method of measurement of slab&beam
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
from where ican get sample papers for CET-delhi 2012
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
What is the diff between cad & cadd?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
