The initial current is very large at the time of starting for almost all DC mot

The initial current is very large at the time of starting
for almost all DC motors. SO WE USE STARTER FOR A SAFE STARTING
but at our homes we don’t see any starters in our coolers,
motors.WHY DON’T WE NEED STARTERS FOR THESE APPLIANCES?

Question Posted / me

1 Answers
3657 Views
I also Faced
E-Mail Answers

The initial current is very large at the time of starting for almost all DC motors. SO WE USE START..

Answer / yaswanth

We all use only A.C motors in house hold purpose,but also
uses small rating of D.C motors which is in
mixers,juicers.it has below 0.25hp motors only.thats they
not require starters for starting

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How can we increase fuel-power ratio of any DG set?

0 Answers

my company total load is 1000kw, 415volt, all load are inductive load. incoming powerfactor is .8. we want to have0.95 pf connecting capacitors. so now how much rating of capacitors we have to connect? show how?

3 Answers

Why an ac systems are preferred over dc systems?

0 Answers

can anybody find out the result. I am lil bit confused about my equation.

1 Answers Student,

What is working principal of V.C.B., O.C.B., A.C.B & Over load relay?

4 Answers Unitech,

1.what is the contact resistace of CB ? 2.radioactivity should be mesured with---------?

3 Answers Power Grid,

why dc exicitaion used in ac motor....?

2 Answers

We know flow of electron is current . But why electron flow from negative to positive and current from positive to negative?

4 Answers Power Grid,

what are the points to be consider for MCB(miniature circuit breaker selection?

3 Answers

I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN

0 Answers

if we know Fault level say 25 KA , How to decide busbar size for Distribution network of 1000 Amp Breaker ? Sample Calculation or Farmula Available or not ?

4 Answers TCS,

in elevator industries , how to calculate the required KVA for the elevator (elevator spec- 40A module , motor of 13.5KW, 20A)

1 Answers DLF, Tata Steel Limited,

For more Electrical Engineering Interview Questions Click Here