What are the protections required in the main lt panel
which is connected to the transformer.
Answer / karthick
1) first thing panel body earthing (it according to the ip/op)
2) proper earthing pit,strips and size
3) proper place and proper air flow ,exiting of air
4) stranded size of panel fabrication and bus bar impulse testing , high voltage testing
Is This Answer Correct ? | 0 Yes | 0 No |
In 3 phase induction motor even with low Voltage it reaches nearly it's rated speed why? (for example instead of 400V it reaches with 250V)
can any one provide some material?
Why armour HT XLPE power cable required to Earth?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
state the working principle of incondenscent tube?
For DG set,if the loading is increased,does flue gas temperature increases or not?
in the Distribution system .which one is Most Economically used by Power Engineer ? a)3 Phase3 wire System or b) 3Phase -4wire System
During the main stator winding insulation testing (phase to ground)of 11kv alternator (Lerysomer) i found 0 and resistance with multimeter and found 20 killo ohm while the power cables are connected both end (Generator & VCB). In VCB PT (Potential transformer) are connected. Please any body explain that method of insulation is correct or not? also describe of PT connections
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
why do we use star-delta starter. what is its need?
what is the contact resistance of sf6 circuit breaker??
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.