What are the tests to be conducted in the electrical
installations
Answer / manteaw
Insulation resitance test for all cable.
Earth resitance test
Conductivity of Protective conductors (CPC)
Polarity Test for sockets.
Contnuity test.
| Is This Answer Correct ? | 2 Yes | 1 No |
what is lrs tank water resistance.
what is ballast
wat is mean by HRC fuse... WHY we choose it...?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
At full load wat is the motor p.f And at no load will is the motor p.f?
How to increase the specific gravity of DG batteries?
why we use MV panels??? what's r all the needs
Q2). When 3 dice are simultaneously thrown, which of the following would be obtained? (a) Result 1: “A 5, a 3 and a 6” (b) Result 2:” A 5 three times” (c) Result 3:”A 5 twice and a 3” (d) All three results are equally likely. (Musigma Question)
We have Diesel generator of 200KW but load connected to it only 100KW. Pl. brief me about fuel consumption.
when the flux enters into saturation mode then what will be the secondary voltage of the normal t/f?....high or low ? explain ...how?
How to work E.L.C.B and how to connect in circuit.
What is rotor angle stability?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)