Answer / knighttezz

BJT is a current controlled voltage device
OPAMP is a Voltage controlled voltage device

Answer / raju kumar

BJT is made up of p-n type of semicoductor . it is used to
amplify the the signal.
Where in OPAMP , it is combination of two BJT. it
is called as oprational amplifier . it is used in integrator ,
differentor, adder etc.

"11101111" when that bit oriented message transmitting from sender to receiver.how is it calculate parity bit and how is it show bit stream that would be transmitted..by even parity error detection scheme..pls send me an answer..very important,,

0 Answers  

---

hi.i want to get cleared about ece and want to know what are the topics or chapters which were in 11 and 12 grade.esp., in maths and physics?ans me soon.i am fresher.

0 Answers  

---

what is practical application of clipper circuit?

0 Answers  

---

What is meant by the temperature coefficient?

0 Answers  

---

how a log ratio amplifier works?

0 Answers  

---

Micro controller input pin voltage is max 5v. If i want give 50 0r 100v input pin. whether is it possible

4 Answers  

---

What is meant by IMSI, TMSI, IMEI and MS-ISDN? Why they are needed?

1 Answers  

---

Why does sidebands vl come in case of analog modulation?

0 Answers  

---

about full wave rectifier and how to remove ripples,circuit diagram and derivation

0 Answers   BARC,

---

what is the use of GPRS AND WHERE IS THE USE IN BEHAVIOR LIFE.

2 Answers  

---

What is meant by CDOT in relation to the Communication in BSNL? Explain the term CDOT.

0 Answers   Alcatel,

---

What is the equivalent of negative logic and gate?

0 Answers  

---