Answer / bal ram gurjjer

YES BECAUSE GENERATOR GENERATE THE POWER AND MOTOR SUPPLY
THE POWER

Answer / hardik085gmdc

i think that churning action done , pl z correct me.

What does a pump develops? Flow or Pressure. Give the Answer with Proper Logic.

3 Answers   DVC,

---

INSTEAD OF BSW THREAD, CAN WE USE BSP ON 1"ROD

2 Answers  

---

In a Steam Turbine, where does the maximum loss of efficiency occur ?

14 Answers   MahaGenco,

---

what is blow by and blow down phenomena in ic engine?

3 Answers   L&T,

---

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

1 Answers  

---

Define coal

0 Answers  

---

what amount of heat energy loss in ESP?

1 Answers   BARC,

---

HELLO SIR VERY GOOD EVENING SIR, I'M KALAMANI. I NEED TO PREPARE FOR UPCOMING "JINDAL STEEL AND POWER LTD" INTERVIEW. I'M MECHANICAL ENGINEER SIR. SO PLEASE SEND ABOUT JINDAL's PREVIOUS APTITDE TEST QESTION PAPERS TO MY MAIL ID : <kalafriends@yahoo.in>, <kalamani.mech@yahoo.com>, <kalajobs@yahoo.in>. I WANT TO KNOW ABOUT THEIR PROCEDURE TO BE HELD ON THE INTERVIEW? SO PLEASE SIR SEND UR VALUABLE ANSWER TO ME ON ABOVE MAIL ID SIR. THANK U SIR.

0 Answers   Jindal, Monnet,

---

Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)

0 Answers   Bhel,

---

Sir, In the current session I am attending the Junior Engineer Exam in Grade II for Mechanical Engineering. If it possible. Please sent the Past Exams Question on my mail. It is so useful use to me.

0 Answers   RRB,

---

if silica is removed from DM Plant completely from where the silica come in Boiler Drum

9 Answers   BARC, SSA,

---

If I can absorb 9,000 lux of sunlight in the bottom of a pool what will the temp rise be per hour, per square foot of absorbing material, per gallon be? Temp of pool deck 115 degrees, water temp 75 degrees, 120,000 lux on the pool deck

0 Answers   ABB,

---