Answer / mirza

ALE IS ADDRESS LATCH ENABLE means to give 8 bit address at
the output with the help of IC 74LS373.basicaaly it is used
to give out or latch the address at the output.

Answer / akshay

Well above answer is correct but I would like to add some
thing more in a simpler way:
As mentioned ALE is Arithmetic Latch Enable. This signal
goes high whenever a new operation is started by MPU(At the
beginneing of each Machine cycle).
Bsing HIGH of this signal means that Data present at
Multiplexed (AD0-AD7) bus is Address and not Data.
It is generally for a single T-state.

Akshay Bisht
(NIT Jalandhar)

Answer / mirza hafez

ALE means address latch enable.It is used to demultiplex address and data.when it is high it will latch address and when it is low it is latch data at the output side.

Answer / prish

ALE STANDS FOR ADDRESS LATCH ENABLE

how the silicon knows 0's and 1's...

0 Answers  

---

We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?

0 Answers   DSPM,

---

basic call setup

0 Answers   Huawei,

---

what is embedded system

3 Answers   TCS,

---

What is the state if the RED LED is glowing on DVxx card What is the state if the YELLOW LED is glowing on DVxx card What is the state if the GREEN LED is glowing on DVxx card Which frequency band DVDC is used Which frequency band DVGA is used What is the function of Bias Tee (BPxx) Which power supply card required for Ultra BTS for AC 230 V input Which power supply card required for Ultra BTS for DC -48V input Which power supply card required for Ultra BTS for DC 24V input What is the state if the GREEN LED is glowing on PWSx card What is the state if the RED LED is glowing on PWSx card What is the state if the YELLOW LED is glowing on PWSx card How many maximum PWSA cards can be inserted in a Ultra BTS cabinet How many maximum PWSB cards can be inserted in a Ultra BTS cabinet How many maximum PWSC cards can be inserted in a Ultra BTS cabinet What is the output power rating of one PWSA card What is the output power rating of one PWSB card What is the output power rating of one PWSC card What is the function of Receiver Multicoupler (M2xA or M6xA) How many TRX's are supported by one Receiver Multicoupler- M2xA How many TRX's are supported by one Receiver Multicoupler- M6xA What is the function of Remote Tune Combiner (RTxx) unit

1 Answers   Nokia,

---

transformer works only on

6 Answers   RRB,

---

What is a low-pass filter?

0 Answers  

---

Explain what are the advantages of using a voltage follower amplifier?

0 Answers  

---

when was first developed dmrc.

0 Answers   DMRC,

---

I have applied for the post of Assistant Instrumentation Engneer in IOCL and need urgently IOCL sample paper please help me.

0 Answers   IOCL,

---

what is de difference between 2g &3g &4g

1 Answers   TCS,

---

write a programme to identify the biggest number from the given three numbers with out using of relational operators

0 Answers  

---