Answer / ashwini kumar

generally two type of accuracy class 5P and 10P.Here, 5P
indicates that this is the protection type of CT with
composite error of <5% at rated accuracy limit primary
current & 20 is the rated accuracy limit factor (RALF) for
the C.T. i.e. overcurrent = 10*nominal current.

[RALF is the primary current up to which the CT is required
to maintain its specified accuracy with rated secondary
burden connected expressed as a multiple of rated primary
current.]

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator gets disconnected from transformer when it is running @ full load?

3 Answers   Areva,

---

my diploma certificate in my higher education college

0 Answers   Aastha Spintex,

---

what is mean by current

17 Answers   Wipro,

---

What is C curve and D curve of MCB?

3 Answers   GMR,

---

What is Peterson coil? Where it is used?

2 Answers  

---

How much load can take a 16 mm aluminum cable 3 phase

0 Answers   L&T, Sanga Energy,

---

why in some trains in India Electric equipment such as Fans , tube light not work until locomotive or engine is attached to the train ??

1 Answers  

---

What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)

0 Answers  

---

Why electrical engineer use Cu Strip for transformer neutral why not GI Strip? What if we use GI instead of Cu does it affects the transformer performance.

7 Answers  

---

Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007

0 Answers   XYZ,

---

What is the difference between bushing and insulators.? what is the creepage distance?

4 Answers  

---

checklist of ELCB

1 Answers   EECE,

---