Interested to Buy Any Domain ? << Click Here >> for more details...
how many types of accuracy class in ct? what is meaning of
5p20?
- 1 Answers
- 7809 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashwini kumar
generally two type of accuracy class 5P and 10P.Here, 5P
indicates that this is the protection type of CT with
composite error of <5% at rated accuracy limit primary
current & 20 is the rated accuracy limit factor (RALF) for
the C.T. i.e. overcurrent = 10*nominal current.
[RALF is the primary current up to which the CT is required
to maintain its specified accuracy with rated secondary
burden connected expressed as a multiple of rated primary
current.]
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
3phase motor can be used as a Prime mover for alternator.
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
bitumar
what is the difference between c power and U power acb breaker
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
What are IR values and what it should be for coil and for insulator
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
what is thresold of perception
why power factor is important?
What is different between Difnit time and instatous over current relay
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
