Interested to Buy Any Domain ? << Click Here >> for more details...
What is the command to start IP RIP version 1 routing on a
Cisco router?
A. show rip
B. enable rip
C. router enable
D. router rip
- 6 Answers
- 9567 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
D.Router rip
This command enable the RIP V1 in the router.
| Is This Answer Correct ? | 8 Yes | 1 No |
What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC
What is a protocol
When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A
Differentiate Logical Topology from Physical Topology
What is public and private ip address., explain? and also explain the ip address range of both public and private? and where we use that public and private ip address?
How many types of data?
what is vc,pvc,lmi and dlsi
Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
What is a backoff on an 802.3 networks A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. it is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged.
Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network
What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d
CCNA 
