What is the command to start IP RIP version 1 routing on a
Cisco router?
A. show rip
B. enable rip
C. router enable
D. router rip
Answer Posted / shahin
Mr. Danish, Cud u justify ur answer. If yes.. thn plzz
justify it. I m eagerly waiting for ur response.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the difference between tracert and traceroute?
Which mathematically form used inipv6?
Explain the difference between simple authentication and md5?
What is the difference between half duplex and full duplex?
What’s the easiest way to remotely configure a router?
What is the difference between rip and igrp?
Explain the difference between bus topology and hub?
Which protocol supenetting is enable by default?
What is difference between routing and routed protocols?
Explain the term 'unicast'.
Hi Jitendera, Wat do u do..?? I mean r u working anywhere???? Basically where r u from??? If u don't hv any problem, u can say..?? Or else mail me mr.shahin07@gmail.com
In eigrp metric parameters which 2 options are enable by default?
What is the difference between named and extended acl?
What is default cost of serial interface in ospf?
Which protocol you manually enable route summarization?