What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds

1 Answers   ACS,

---

What is the Broadcast IP Address?

14 Answers  

---

What is the beaconing?

0 Answers  

---

How many maximum paths you can give on latest ios in rip?

0 Answers  

---

Identify 3 Fast Ethernet technologies? A.) 100 Base FastEther B.) 100 Base FX C.) 100 Base T4 D.) 100 Base TX

2 Answers  

---

There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton

3 Answers  

---

What is the default behavior of access-list?

0 Answers  

---

What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip

6 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Gandalf5 B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) SAP

2 Answers  

---

Why Clock rate command is not configured on ethernet interface of a router?

6 Answers  

---

Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip

2 Answers  

---