Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

Which OSI Reference Layer controls application to application communication? A.) Datalink B.) Network C.) Transport D.) Session E.) Physical

2 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

Identify 3 IP applications? A.) AURP B.) ARP C.) Telnet D.) SMTP E.) DNS F.) RARP

2 Answers  

---

what is routing and routed protocol ?

7 Answers  

---

What is difference between igp and eigrp?

0 Answers  

---

Why we use filter option?

0 Answers  

---

255.255.255.128/what is the n/w id ,broadcast id and the number of valid host(according to disco rules)

5 Answers   Reliance,

---

Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?

0 Answers  

---

What does 'P' mean when running a Trace? A.) Good route B.) Protocol unreachable C.) Source Quench D.) Destination unreachable

1 Answers  

---

UDP works at which layer of the DOD model? A.) Internet B.) Host-to-Host C.) Transport D.) Data Link

1 Answers  

---

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers  

---