What is the minimum distance between taransformer (say 2000
kva)and its earth pit?

Answers were Sorted based on User's Feedback



What is the minimum distance between taransformer (say 2000 kva)and its earth pit?..

Answer / sidda raghavendra

Its all depends on the amount of insulation between them
rather than the distance

Is This Answer Correct ?    4 Yes 0 No

What is the minimum distance between taransformer (say 2000 kva)and its earth pit?..

Answer / k.prakashchandra

Equal to the length of the earthing electrode. Actually
earth wire should not be very long to increase effective IR
value and earth pit should not be a hindrance being very
close.

Is This Answer Correct ?    2 Yes 8 No

Post New Answer

More Electrical Engineering Interview Questions

In an ideal transformer no load primary current I0 A lags behind V1 by 90 degree B is in the phase with V1 C leads V1 by 90 degree D lags V1 by 45 degree

1 Answers  


What is the ampereage of .75 ton Ac

1 Answers  


What is the size of electrical cable to be used for a space heater single phase 240V ?

3 Answers  


avr is an automayic voltage regulator ... it regulates voltage before it synchronise with grid after synchronisation it regulates power factor why....

7 Answers  


Why temperature rise is conducted in bus bars and isolators?

0 Answers  






According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?

5 Answers   KEC,


give information about REM5453 & SPAJ Relays

1 Answers  


defination of transistor controlled series capacitor

0 Answers  


whats the reletion betweet flow,pressure,head,rpm and motor rating?

1 Answers  


I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.

0 Answers  


what are check points to be checked while charging switchyard?(CT,PT,BREAKER,POWER TRANSFORMER)

1 Answers  


How CT is connected to measure current by changing plug setting , ratio is 300 - 150 / 5 A ?

1 Answers   Ajanta Pharma, Bhel, Cosmo Films, Suzlon,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)