Answer / ravi

it measure flow rate of a liquid or gas by relating linear
displacement of an internal "float" or sharp-edged orifice
plate (Lake Monitor) to a corresponding flow rate.

what is the difference between absorber and scrubbers

4 Answers   Parco,

---

ENVIRONMENTAL ENGINEERING - QUESTION 22.3 : A well delivers 225 US-gallons per minute of water to a chemical plant during normal system operation. (a) Calculate its flowrate in the unit of mega US-gallon per day or MGD. (b) The following formula is written next to the chlorine feed point : (chlorine feed rate, lb / day) = (flowrate, MGD) X (dose, mg / L) x (8.34). If this formula is correct, then what should the chlorine feed rate to be in pounds per day (lb / day) if the desired dose is 2 mg / L. (c) Prove by calculations that the constant 8.34 in the formula next to the chlorine feed point is correct. Let 1 US-gallon = 3.78541 L and 1 mg = 0.0000022046 pound.

1 Answers  

---

which thing is responsible for making petroleum?

6 Answers   OGDCL,

---

What type of heat exchangers are most commonly used for a large-scale plant-cooling loop using seawater as the utility?

0 Answers  

---

Is there a handy way to determine if a horizontal pipe is running full if the flow rate is known?

0 Answers  

---

UNIT OPERATION - EXAMPLE 9.1 : Which of the sequence below represent a feasible flows of ethanol processing plants using cellulose as starting material? A. raw material -> heat exchanger -> distillation column -> reactor. B. reactor -> distillation column -> raw material -> heat exchanger. C. heat exchanger -> raw material -> distillation column -> reactor. D. raw material -> heat exchanger -> reactor -> distillation column. E. distillation column -> raw material -> reactor -> heat exchanger.

1 Answers  

---

What do you know about us?

4 Answers   Allfon, Bhushan Power Steel, CPCL, Crystol, Trident,

---

What are the effects of oils on the properties of Polyolefins?

0 Answers   IOCL,

---

What is a good method of steam tracing large vessels?

0 Answers  

---

how to convert Nm3/hr to Kg/hr for air, @ 10.4 kg/cm2.g dischare pressure, does density doesn't affect on calculation?

1 Answers  

---

Which type of drier is used for drying wet material?

3 Answers  

---

Question 45 - According to Raoult’s law for ideal liquid, x (PSAT) = yP where x is mole fraction of component in liquid, y is mole fraction of component in vapor, P is overall pressure and PSAT is saturation pressure. A liquid with 60 mole % component 1 and 40 mole % component 2 is flashed to 1210 kPa. The saturation pressure for component 1 is ln (PSAT) = 15 - 3010 / (T + 250) and for component 2 is ln (PSAT) = 14 - 2700 / (T + 205) where PSAT is in kPa and T is in degree Celsius. By assuming the liquid is ideal, calculate (a) the fraction of the effluent that is liquid; (b) the compositions of the liquid and vapor phases. The outlet T is 150 degree Celsius.

1 Answers  

---