Answer / pavan kumar

dig a small hole and take a safety pin and give your
connection to it and close the hole and pour some water.

how to test YNyn0 vector group in transformer?

0 Answers  

---

what is FACTS & where i can material regarding to facts.

2 Answers  

---

What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?

0 Answers  

---

WHAT HAPPENS IF FUSE IS CONNECTED TO NEUTRAL WIRE

5 Answers  

---

in star delta starter current is 1/3times the delta value how?

2 Answers  

---

what is the difference b/w earthing and grounding??

2 Answers   Dodsal,

---

What are methods to avoid the inrush current at the time of starting of power transformer ?

8 Answers   Wipro,

---

what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct

0 Answers  

---

whatis knee point ?

5 Answers   L&T, Siemens,

---

What is the difference between a 3 winding and 2 winding Potential Transformer

0 Answers   Engineers India,

---

Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.

0 Answers  

---

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

0 Answers  

---